01:54Wooden Comic box // How-To | I Like To Make Stuff
From the creator
I wanted to make a box to hold my comic books collection and I needed a reason to try out my Incra box joint jig. What you'll need: http://amzn.to/1IZxDbg - Wood glue http://amzn.to/1JeObO3 - Table Saw http://amzn.to/1SVz1Ub - Formby's Tung Oil Finish http://amzn.to/1fqtm69 - Corner clamps http://amzn.to/1fqt9Qf - Incra Box joint jig http://amzn.to/1WFP9Zo - 8" dado stack http://amzn.to/1hNmjpS - Trim router I cut one piece of 1/2" plywood down to 24"x24". This will become the side panels. I ripped another piece to 8 1/2" wide to use as the ends. I switched out the blade for a dado set, so I could cut 1/4" dados. I set the saw to only cut 1/4" deep. I cut a dado every inch across the whole board. I left 1 1/2" on each end. This piece was cut in half, perpendicular to the dados. I trimmed the end pieces to the same height as the side panels. This is my first time using this Incra box joint jig. It takes a little bit to setup, but then it's very easy to use. I clamped together the end pieces and cut finger joints on one side. Keeping them lined up, I moved the clamps to the other side. Then I cut matching fingers on the other edge. I clamped together the side panels. Then I cut fingers on both ends of the panels. The cut outs were cleaned up with a rolled up piece of sandpaper. On each piece, I clamped down a straight edge about 3" up. I used this as a guide to cut a rabbet along the bottom edge of all four pieces. I added glue to all of the cut outs, then assembled the finge
Published 2015-08-25 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





