tubeshowcase●1,672,869 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts04:01

Water Balloon Cannon // How-To | I Like To Make Stuff

I Like To Make Stuff ↗

From the creator

I made this impromptu water balloon cannon for my kids to play with! It's a simple quick project made to be fairly safe. TOOLS LIST: https://kit.co/iliketomakestuff/my-woodworking-tools 4" PVC pipe (3' long) 3" PVC cap 1" PVC pipe (2' long) I used a 3' length of 4" and 1" PVC pipe. I also used a 3" cap which fits right inside the large pipe. I traced the smaller pipe on the larger one, marking it a little larger than real life. I marked a cross line several inches from one end. I ran it through the bandsaw which cuts the line on the top and bottom of the pipe, to cut both lines. I used a cut off wheel on a Dremel to trim the piece out. I switched the wheel out for a grinding stone and cleaned off the corners of the cut. This is to cut down on friction. I made sure the smaller pipe fit in the slot and moved freely. Then I made sure there was enough space on each side for a hand, and marked the pipe. I cut the small pipe along that mark then rounded over the ends on the disc sander. With the cap, I used the belt sander to carve out a small dip in the  top. Then back to the disc sander with the cap. I sanded down the entire outside  of the cap to make it's diameter a little smaller. When you cut the section from the PVC, it puckers a little, making the interior size a little smaller. Sanding the cap makes it fit better inside. I drilled a small hole in the center of the cap. Drilling from the inside of the cap helps drive the bit to the center. I also drilled a hole in the mid

Published 2016-04-07 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts