37:34Underwater laser cutting and silver sintering to make ceramic circuit boards
From the creator
Thermal stress cracking can be completely avoided by CO2 laser cutting thin alumina sheets underwater. I also show how to formulate and apply silver paste, then sinter in a kiln to produce double-sided ceramic printed circuit boards with conductive vias. 60W CW CO2 laser at 80% power. 10mm/sec. Standard lens focal length (50mm). 2mm water above ceramic. 180 passes to cut through 0.75mm thick alumina. Silver paste: 97% silver powder, 3% glass powder by mass. Particle size 1 micron or less. Add poly vinyl alcohol mold release until desired consistency reached. Paste applied with 4 mil thick vinyl stencil. Dried in air 10 minutes, then rapidly brought up to 900*C, held for 10 minutes, then rapidly brought back down to room temperature. Total cycle about 45 minutes. I measured electrical conductivity of the finished traces from my process with vinyl stencils: 4 milliohms per square at 10 micron final thickness. This is pretty close to the Dupont published spec ( less than 2 milliohm/sq at 16 micron thick) Underwater CO2 laser cutting reference: https://sci-hub.se/10.1016/J.JEURCERAMSOC.2011.06.015 60W laser cutter: https://www.ebay.com/itm/294386493292 Ceramic sheets at McMaster: https://www.mcmaster.com/alumina/nonporous-alumina-ceramic-sheets-and-bars/ Ceramic PCB prototypes: https://ceramic-pcb.com/product/alumina-pcb-al2o3-pcb-prototypes-online/ Quickfire kiln: https://kruegerpottery.com/products/par_quikfire6 Raspberry Pi picoReflow oven controller: https://a
Published 2021-09-26 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.
Keep exploring Engineering
37:34
42:45
12:58Knowledge Marine & Engineering Works Ltd चा Dredging Business Analysis | Value Chain Analysis
Thodkyat Sangato
12:11Cold Store Racking Start | Complete Guide | M Alam and Sons Engineering Works
NawbZada 50.5M Views 2 day ago ...
01:53
01:33WALL PUTTY AND TILE ADHESIVE PLANT | LAXMI ENGINEERING WORKS
Laxmi Engineering works (Hariom Saini)
04:14