01:54Tool Storage Shelf | Build It | Ask This Old House
From the creator
Ask This Old House general contractor Tom Silva and host Kevin O’Connor build a tool storage shelf out of leftover lumber from other Build It projects. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 5-6 hours Cost: $0 and up, depending on how much leftover lumber is available Skill Level: Moderate Tools List for Building a Tool Storage Shelf: Track saw [https://amzn.to/38xOGCY] Drill [https://amzn.to/38wP9oU] Forstner bit [https://amzn.to/2TPiKG4] Jigsaw [https://amzn.to/2RKRcin] Router [https://amzn.to/2vfA78F] Shopping List: 5/8-inch plywood for cabinet [https://amzn.to/2RF5pNS] ¼-inch plywood for adjustable dividers [https://amzn.to/2RF5pNS] 1x10 or wider lumber [https://amzn.to/2GjBDJi] Cup [https://amzn.to/37mSjLJ] Wood screws [https://amzn.to/3azmvoV] Steps: 1. Cut the plywood into 5 sheets until you can frame a cabinet to the desired dimensions, with one board as a divider. In this case, Tom cut the plywood to form a 3-foot x 4-foot x 1-foot cabinet. 2. On the bottom shelf, measure and mark good locations for the fingers. Make them evenly spaced. 3. Drill holes at the peak of each finger using a forstner bit to ensure it has a rounded edge. Tom advises putting a sacrificial board underneath the bottom shelf to prevent blowout, and another board on top to act as a straight edge to ensure each finger terminates at the same depth. 4. To make the outside edges of the fingers round, take a cup and trace the curve on the board. 5. Cut out t
Published 2020-01-27 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





