01:39The Real Lathe Project (Pt1: Bed and Headstock)
From the creator
More video and exclusive content: http://www.patreon.com/rexkrueger Parts for this build || Bearings: https://amzn.to/2zWcqlF (affiliate; scroll for more) 3/4 inch shaft: https://amzn.to/2y5d6DQ (this shaft is a little bit pricey, but it's enough for BOTH the headstock and the countershaft we'll be building in the future, so it's a good buy.) 3/4 Shaft collars: https://amzn.to/2zW4Rvs Tools: 34mm Forstner Bit: https://amzn.to/2zW09h4 35 mm bit (WAY cheaper) https://amzn.to/2y50D3j 1 1/4 spade bit (the one I used): https://amzn.to/2C1Dxxh Drill/impact: https://amzn.to/2RyxNR1 Table saw: https://amzn.to/2zXvyjg In this first part of the Real Lathe Project, I build the bed, ways, and headstock for a full-size wood-turning lathe. This will be a rigid, high-capacity lathe capable of doing big bowls and long spindles. I plan on 8 speeds, even though we're just going to use a standard AC motor. All-told, I expect this project to cost $100-$150 and maybe a lot less, depending on how good you are at scrounging materials and parts. Follow me on instagram: @rexkrueger
Published 2018-10-08 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





