02:47DIY✨ Galaxy glitter🪩 bookmark!! #shorts #trending #craft #ytshorts #viral #diycrafts #craftideas
Twinnies Fun world
Turning the 3d printer to change the filament is kind of a pain, so I made a way to spin it, and store filament and tools! GET MORE INFO ON THIS PROJECT: http://www.iliketomakestuff.com/make-spinning-3d-printer-workstation HERE'S WHAT YOU'LL NEED: http://amzn.to/1NCVmAb - SawStop cabinet saw http://amzn.to/1GMrfGL - Dewalt 20v drill driver combo http://amzn.to/1HdQuwD - Grizzly G0555LANV Bandsaw http://amzn.to/1GyGjbg - Grizzly Drill Press http://amzn.to/1ntzLSF - Silicone spray http://amzn.to/1ntzEGI - 12" lazy susan bearing http://amzn.to/1WnkyhQ - Pancake compressor/ brad nailer combo http://amzn.to/1LZGfxW - Ultimaker 2 Extended 3D printer I used scrap plywood for this project, so it was a combination of 1/2", 3/4" plywood and MDF. I cut down three pieces to 14 3/4" squares, as this was a little larger than the footprint of my printer. I cut a couple of strips for the side panels. These were a little taller than the diameter of a filament roll. On one of these pieces, I centered a filament roll and traced the inner circle. I made a mark at the far outside of the circle, and drew in a place for a 1/2" dowel hole. I lined the two pieces up and drilled a 1/2" hole through both. I sat the side pieces in place on the base and traced the edge. This shows me the safe area to drill holes. I did the same for the other square piece. On both pieces, I drilled countersunk holes in the safe area. The side pieces got glue on one side before being screwed to the bottom square. I mist
Published 2016-01-21 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.
02:47Twinnies Fun world
01:32Daisy Arts
03:01
11:39123 GO! FOOD
10:02
03:34
01:40𝚌𝚞𝚝&𝚌𝚘𝚕𝚘𝚛 𝚋𝚢 𝚊𝚖𝚒
Allow Google Analytics to measure visits. Your history stays in your browser. Privacy details