01:39Sandbox/planter combo // How-to | I Like To Make Stuff
From the creator
We needed a new sandbox for the kids, but also wanted to plants some herbs. This planter/sandbox is really simple to make! For more info check out http://www.iliketomakestuff.com/how-to-make-a-sandboxplanter-combo First, I had to get rid of my old scrap built sandbox. I dumped out the sand to help level the ground below. I had the store cut down a sheet of 3/4" treated plywood to 18"x48" and 36"x48" The sandbox is a simple 36"x48" box, made of 2x6's. (Cut the pieces to 33" and 48") I connected them together with 3" decking screws. Pressure treated wood is so wet that it doesn't split easily if you don't pre-drill the holes. I screwed on the 36"x48" piece of plywood to the box, using lots of screws. This piece supports the weight of the sand, so attach it well! For the legs, I cut 8 pieces of decking boards, 24" each. These were screwed to the box with shorter screws, so they didn't poke through into the sandbox. I tied each corner together by screwing the pieces to each other. The planter box was built the same way, but with 48" and 15" pieces of 2x8. I screwed on the plywood bottom (18"x48") as before. I made and attached the legs for the planter in the same way but only needed two legs. The height of these is the total height of the sandbox plus the height of the planter box. I drilled a few small holes around the sandbox for drainage. Luckily, the sandy soil where I live made it easy to level the pieces and line them up. I connected the two pieces with a few screws thr
Published 2015-06-02 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





