01:39Reclaimed Wine Rack | Build It | Ask This Old House
From the creator
Ask This Old House general contractor Tom Silva and host Kevin O’Connor build a wine rack out of a reclaimed beam. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 6-7 hours Cost: $500 Skill Level: Moderate Tools List for Building a Wine Rack: Miter saw Surface planer Clamps Table saw Metal detector Router Palm sander Drill Pocket hole jig Mortising drill Air compressor Brad nailer Block plane Shopping List: Preferred lumber for base, top, and rails Wood glue 150 grit sandpaper Wood screws Floating tenons Brad nails Steps: 1. If using old wood, start by checking the pieces for old nails using a metal detector and pull them out before they damage any of the tools for the project. 2. Start by cutting pieces for the top of the wine rack to size with the miter saw. 3. Fasten the top of the wine rack together using wood glue and clamps. While the glue dries, work on the rest of the rack. 4. Rip the legs down to 2”x2” using the table saw. Then, run all the legs through the surface planer as well. Turn each leg to ensure all four sides are smooth, but also stay square. 5. Use the router to cut stop dados in the legs to accept the wood for the back and sides. 6. Cut 1” stiles for the sides and back of the wine rack. Make dado cuts with the router to accept the lumber for the rails. 7. Cut the lumber being used for the rails to size using the table saw. Make rabbet cuts in the lumber using the router. 8. Give all the pieces a light sanding using the
Published 2019-03-31 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





