18:08Quick Tip: How To Replace The Polarized Film On an MSLA Resin 3DPrinter
From the creator
full article: https://makezine.com/2021/05/13/replacing-the-polarized-film-on-your-resin-3d-printer/ Polarized film: https://amzn.to/34pEDmO Bearded Yell sculpt: https://www.prusaprinters.org/prints/38375-the-bearded-yell Here are the steps to replacing your polarized film. Keep in mind, your specific printer might not have a removable film. Remove the old one. Carefully scrape and peel your old one off. This is tricky and scary. You'll need a clean razor blade and some patience. Keep some scraps to compare to the new film you get. clean clean clean there will be bits of glue residue left behind. I used alcohol to remove it. Acetone might work as well (but acetone can melt many plastics, so test in a corner). You're going to need this LCD screen perfectly clean. Acquire the proper replacement. This is the tough part. There's often zero documentation on what film will work! Even the printer manufacturer has no idea as the film comes pre-applied on the displays! I used this one (Affiliate Amazon Link). It worked quite well. I experimented with this one first (Amazon Affiliate Link) and it did not block enough light. I didn't notice that it says "not for 3d printers" in the description. find the correct angle lay the sheet on the printer, fire up the UV light source, and slowly rotate the sheet to see where it blocks the most light. Look at the video above for this in action. You CAN NOT simply cut a rectangle and plop it on. You need to have it at the correct angle. c
Published 2021-05-13 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





