tubeshowcase●1,669,062 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts05:12

Overhead camera rig // How-To | I Like To Make Stuff

I Like To Make Stuff ↗

From the creator

I needed a rig for overhead video production on my new electronics station, so I grabbed some LEDS and knocked it out in an afternoon! MORE DETAILS: http://www.iliketomakestuff.com/how-to-make-an-overhead-camera-rig ALSO CHECK OUT THERE OTHER RIGS: Darbin Orvar - https://www.youtube.com/watch?v=KQ4ORaQLx9g Casey Neistat - https://youtu.be/vb60rrtTddQ?t=292 Special thanks to Jesse Hughson for his awesome support on Patreon! He made this video possible! HERE'S WHAT YOU'LL NEED: http://amzn.to/1QbG0TW - Boom microphone stand http://amzn.to/1Uq7R8D - Gorilla pod (better deal) http://amzn.to/1L869i3 - Joby tripod head only http://amzn.to/1KTZHAq - MIG welder http://amzn.to/1UreqEG - Welding mask (auto darkening) http://amzn.to/1Dxukcc - Welding gloves http://amzn.to/1UreDYv - Welding magnet http://amzn.to/1gjdrqU - Angle grinder http://amzn.to/1T0GBNj - Cut off wheels http://amzn.to/1Uq7KKp - LED strip set http://amzn.to/1P9bHN6 - Soldering iron http://amzn.to/1hm39qY - Wire strippers (not the ones I have, but good ones) http://amzn.to/1eVTjKG - Thin solder http://amzn.to/1IoZ2TG - Solder tip cleaner http://amzn.to/1DtOnsn - Fiskars cutting mat I used 3/4" angle iron, 1/2" square tubing, flat steel and solid rod. I measured four pieces of the square tubing to 18" each. These were cut off with a cut off wheel on the grinder. I cleaned up the cut edges with a flat file. The 36" angle iron are the verticals, the square tubing is for the horizontal support. I used magnets to hold

Published 2015-09-15 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts