01:39Making Simple Steel Storage while Learning to Weld | I Like To Make Stuff
From the creator
My metal storage was a disaster, so I made a simple steel storage rack while Josh was learning to weld. The entire storage rack was made from existing scrap metal that now holds scrap metal. Come see his skills grow from shaky YouTube research to pretty decent welds! TOOLS & SUPPLIES WE USED(affiliate links): https://kit.co/iliketomakestuff/my-metalworking-tools https://kit.co/iliketomakestuff/shop-safety-gear MUSIC: http://share.epidemicsound.com/iltms As you may have seen in the latest Between the Builds video, we have been rearranging the entire shop to make room for the new mill and metal lathe. After moving, I found that I had tons of scrap metal tubes, bar stock and angled pieces. I needed to make a steel rack to store this scrap similar to the organization bins at Lowe's or Home Depot. I drew up a design that involved three vertical bins partitioned off into nine square holding areas. These three bins would step down in size from tallest to shortest in the front. Because I have a lot of pieces of varying size, I didn't want the small chunks to fall to the bottom of a big tub. I cut down some 1" square tubing that I had in the appropriate lengths to create the rack's skeleton. The floors of each bin were made from some left-over expanded steel sheeting that I cut with a cutoff wheel on my angle grinder. With the design ready and all of the materials cut, it was time to start welding. This time, I wasn't going to do the welding. Josh has always wanted to weld a pro
Published 2020-03-05 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





