tubeshowcase●1,671,863 videos♡ My collection 0
← Engineering

Engineering08:44

Installing A New Differential In My Honda S2000!

Engineering Explained ↗

From the creator

How To Remove And Install A Honda S2000 Differential Ball Joint Removal Tool - http://amzn.to/2o41OZS Subscribe for new videos every Wednesday! - https://goo.gl/VZstk7 PuddyMod Product Info: PuddyMod Products - https://goo.gl/h2ryZz E-mail - [email protected] Product Links: Ball Joint Removal Tool - http://amzn.to/2o41OZS Diff Mount Front (A) - http://amzn.to/2nCfDCl Diff Mount Rear (B) - http://amzn.to/2nC6TMI Transmission Jack - http://amzn.to/2nCqdJR Electric Impact Wrench - http://amzn.to/2o2o714 Digital Torque Wrench (1/2") - http://amzn.to/2osmDO1 Digital Torque Wrench (3/8") - http://amzn.to/2oLzXjS Paint Pen/Marker - http://amzn.to/2oWGoB0 Removal/Installation Process: 1. Raise the car up onto jack stands. Remove the rear wheels. 2. Remove the exhaust from the catalytic converter back. Remove the rear suspension stiffener. 3. Remove the differential side of the prop shaft, marking all the joints disconnected. 4. Pull the prop shaft slightly back, and allow it to rest on the shaft protector. 5. Disconnect the lower control arm by removing the lower ball joint. 6. Remove the ABS sensor harness by removing two bolts from the upper arm. Repeat these steps to remove the ball joint and ABS sensor for both sides of the vehicle. 7. Remove the differential joints for each side. There are six mounting bolts and nuts to remove, and then you can remove the joint from the differential. This requires pulling the half shaft away from the differential to

Published 2017-04-19 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring Engineering