13:51How to Wire an Above Ground Pool Pump | Ask This Old House
From the creator
Ask This Old House master electrician Scott Caron teaches the safest way to wire a pool. #ThisOldHouse #AskTOH SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Cost: $250 Time: 4 hours Skill Level: Moderate Tools List for Wiring an Above Ground Pool Pump: Shovels Drill with Spade Bit Screwdriver Lineman’s Pliers Wire Strippers Shopping List: 12-2 non metallic cable 12 gauge wire 8 gauge wire Electrical boxes and conduit Flexible sealant PVC glue Red caution tape Post for outlets Timer for Pool Pumps Twist lock receptacle Weatherproof cover GFCI circuit breaker Wire nuts Steps: 1. Working with electricity around a pool can be dangerous. Working with a licensed electrician is recommended. 2. Before doing any electrical work, ensure the power is turned off at the circuit breaker. 3. Dig a 24” deep trench for the underground wire. 4. Drill a hole to the inside of the house where the electrical panel is located. Use an extension if needed to get through the wall. 5. Fish two 12-2 non metallic cables through the hole into the basement, then attach them to a plastic electrical box. 6. Run conduit from the box into the trench. Continue the conduit into the trench and then into the post. 7. Feed three individual 12 gauge wires through the conduit into the post. 8. Mount the timer to the wall. 9. Wire the twist lock receptacle. 10. Plug in the pool pump and cover it with a weatherproof cover. 11. With the main service off to the house, wire in GFCI circuit br
Published 2018-08-06 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





