35:15How to Tighten a Loose Newel Post | Ask This Old House
From the creator
Ask This Old House carpenter Nathan Gilbert travels to a Sears kit house in Richmond, Virginia to tighten an old, loose stair railing. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 2-3 hours Cost: $50 Skill Level: Moderate Tools List for Tightening a Loose Newel Post: Level [https://amzn.to/2GJ80Bc] Drill driver [https://amzn.to/2RNofUq] ¾-inch Forstner bit [https://amzn.to/2RNobEa] 3/16-inch drill bit [https://amzn.to/2RIPsHM] Japanese pull saw [https://amzn.to/2tkzD0w] Framing square (optional) [https://amzn.to/36N2x6W] Paint brush [https://amzn.to/38VgVeV] Shopping List: 6-inch structural screws [https://amzn.to/37LJuLN] 2x4 scrap wood [https://amzn.to/2S6xZrD] Shims [https://amzn.to/38YBoPU] Painter’s tape [https://amzn.to/2UezvdO] ¾-inch wood dowel [https://amzn.to/2GHAVWq] Wood glue [https://amzn.to/2ub5n8y] Paint [https://amzn.to/2UcwYAT] 220 grit sandpaper [https://amzn.to/3aSW9ym] Steps: 1. Start by identifying structural parts of the stair that could be used to attach additional fasteners from the railing to the stairs. The stringer is usually at least an inch thick on the edges of the stairs. Look for nail holes in the treads to help find it. 2. Plumb up the newel post by holding a level up to the side. Once it’s in the correct position, use a 2x4 or other piece of scrap wood against the wall and the post to hold it in that position. Place a few shims both on the wall and on the post in between the board to prevent it from scratching
Published 2020-02-03 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





