09:49How to Run Underground Power to a Shed | Ask This Old House
From the creator
Ask This Old House master electrician Scott Caron turns a shed into a powered-up hangout by running electricity underground. #ThisOldHouse #AskTOH SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 1-2 days Cost: $4000-5000 Skill Level: Difficult Tools: Trenching machine Shovel Propane torch Concrete mixer Hole Saw Drill/Driver Screwdriver Shopping List: 1 ½-inch PVC conduit pipe PVC junction boxes UF 6-gauge electrical wire UF 6-4 electrical wire NM 14-2 electrical wire Electrical wiring boxes Breakers Electrical Sub Panel Masonry screws Steps: 1. A project like this should only be performed by a licensed electrician. 2. Before digging, call the utility locating service to mark any underground pipes or wires. 3. Begin by digging a trench from the house to the shed. This can be done with a trenching machine or a shovel. The trench should be 18 inches deep to bury electrical conduit according to code. In some cases, you may not be able to reach that depth due to site conditions. 4. Spread out a layer of sand into the trench to protect the conduit from sharp rocks. 5. Lay out the lengths of 1 ½-inch PVC conduit to go from the house to the shed. 6. Use PVC cement solution to coat the inside of each pipe and connect them together. 7. To make the PVC pipe conform changes in grade, use a propane torch to heat the pipe and make it pliable. 8. Form the shapes needed and lay the PVC conduit in the trench. 9. Use 90 degree PVC fittings to connect the
Published 2017-02-06 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





