tubeshowcase●1,671,018 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts03:51

How to Replace a Plumbing Shut-Off Valve | This Old House

This Old House ↗

From the creator

Plumbing and heating contractor Richard Trethewey shows how to replace an old, corroded water-supply valve, without soldering. (See below for a shopping list and tools.) SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse This Old House plumbing and heating contractor Richard Trethewey replaces a water supply shut-off valve. Cost: $6 to $12 Time: About 1 hour Difficulty: Easy. Only requires basic plumbing skills Shopping List for How to Replace a Plumbing Shut-Off Valve: Stop-and-waste valve [https://amzn.to/2LrtUfm] with compression fittings [https://amzn.to/2Q2iWkQ], used to replace old valve Emery cloth [https://amzn.to/32ySFfp], used to clean existing pipe Tools for How to Replace a Plumbing Shut-Off Valve: Mini hacksaw [https://amzn.to/2NVsmfE], used to cut old valve from existing copper pipe Pliers [https://amzn.to/2N9XzMm] and adjustable wrench [https://amzn.to/2NVmdQy], for tightening fittings on new valve Steps: 1. Shut off the water leading to the valve being replaced. 2. Use emery cloth to buff clean the pipe on either side of the old valve. 3. Cut through the pipe on each side of the old valve with a mini hacksaw. 4. Slip new stop-and-waste valve into place between the just-cut pipe ends. 5. Grab hold of the valve with pliers and use an adjustable wrench to tighten one of the valve's compression fittings onto one of the pipe ends. Repeat for the other pipe end. 6. Turn the water back on, then open and close the new valve; check your work

Published 2014-12-27 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts