18:08How to Replace a Pedestal Sink Pop-Up Assembly | This Old House
From the creator
Richard Trethewey makes a challenging bathroom renovation task look easy. (See below for a shopping list and tools.) SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse This Old House plumbing and heating contractor Richard Trethewey replaces an old, faulty pop-up drain. Steps for Replacing a Pedestal Sink Pop-Up Assembly: 1. Close the sink's hot- and cold-water shut-off valves. 2. Disconnect the hot- and cold-water supply lines. 3. Remove the toggle bolts securing the sink bowl to the wall. 4. Use wrench to disconnect drainpipe behind pedestal. 5. Pull the pedestal away from wall and lift off sink. 6. Remove and save the trap from the sink. 7. Loosen the nut holding the tailpiece to the sink. 8. Put bead of plumber's putty around new pop-up assembly. 9. Insert the new pop-up assembly to sink's drain hole. 10. Tighten nut on underside of sink; remove excess putty from inside of sink. 11. Re-attach the trap and stand the pedestal and sink back into position. 12. Bolt sink back to wall. 13. Make final plumbing connections, including sink trap. 14. Open the shut-off valves and check for leaks. Shopping List for How to Replace a Pedestal Sink Pop-Up Assembly: - Pedestal Sink - Lead-Free Solder - PVC Cleaner and Solvent, for joining PVC pipe - Flux, acidic paste applied to copper before soldering - Fine-Grit Sandpaper Roll, for polishing the outside of copper tubing before soldering - Fender Washers and 2 1/2-inch Lag Screws, two each, for attaching sink basin to
Published 2014-12-24 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





