09:49How to Repair Toilet Tank Components | Ask This Old House
From the creator
Ask This Old House plumbing and HVAC expert Richard Trethewey explains the failure points in toilet tanks and how to repair them. #ThisOldHouse #AskTOH SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 30 minutes-1 hour Cost: $10 and up Skill Level: Moderate Shopping List: Toilet flapper [https://amzn.to/30b0Aj9] Fill valve replacement parts [https://amzn.to/2tKX9U4] Steps: 1. Every toilet tank has only a few components that can fail and cause the toilet to stop operating properly: the flush valve, and the fill valve. 2. If there’s a failure with the flush valve, it’s possible that the attached rubber flapper has worn off or isn’t sitting properly in the opening. There are two things to check in order to repair this: a. The slack on the chain connecting the flapper to the lever. If it’s too loose or too tight, adjust it so the flapper lifts high enough to flush the toilet and then seals tightly again. b. The condition of the rubber flapper. If it’s worn out, it needs to be replaced. i. Start by shutting off the water to the toilet tank. ii. Pull the old flapper off the flush valve. There are usually two little ears on the side where the flapper loops on. iii. Put the new flapper on using the same process in reverse. iv. Hook the chain onto the tank lever and make sure it’s adjusted properly. v. Turn the water back on. 3. If there’s a failure with the fill valve, it’s possible that the float hasn’t been adjusted properly and excess water is fa
Published 2020-01-15 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





