01:39How to Reconnect a Radiator | Ask This Old House
From the creator
A homeowner’s radiator sprung away from the pipe when he tried to replace the valve, so Ask This Old House plumbing and HVAC expert Richard Trethewey heads to his house to help him reconnect it SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 1-2 hours Cost: $50 Skill Level: Difficult Tools List for Reconnecting a Radiator: Spud wrench [https://amzn.to/35yvZhX] Pipe wrenches [https://amzn.to/31f9tY0] Ratchet straps [https://amzn.to/2ORaXVQ] Shims [https://amzn.to/2OQlMrd] Shopping List: Hose [https://amzn.to/2BeSWbV] Radiator valve [https://amzn.to/35HkTHx] Pipe dope [https://amzn.to/2MNaZLy] Single strand wicking [https://amzn.to/2IQ6ONN] 2x4’s or other scrap wood [https://amzn.to/32kEniO] Steps: 1. Start by shutting off the boiler and the cold water feed to the boiler. 2. Drain the system using a hose and vent each radiator in the house. 3. Remove the temporary caps using the pipe wrenches. When using the wrench, be sure that it touches the pipe in three places so it does not damage the pipe. 4. Disconnect the spud from the radiator valve. 5. Apply the pipe dope to the threads of the spud and seal it with the single strand wicking. 6. Using the spud wrench, carefully tighten the spud in position. Be sure the threads correctly catch to prevent damage to the spud. 7. Apply the pipe dope and wicking to the pipe coming up through the floor. 8. Thread the other half of the radiator valve onto the pipe, again being cautious of cross threading.
Published 2019-10-20 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





