tubeshowcase●1,673,666 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts08:37

How to Prehang a Salvaged Door | Ask This Old House

This Old House ↗

From the creator

Ask This Old House general contractor Tom Silva shows a homeowner how to turn an old door into a prehung door for a new opening SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 5-6 hours Cost: $150 Skill Level: Advanced Tools List for Prehanging a Salvaged Door: Four Foot Level Tape Measure Miter saw Drill/driver Pneumatic nailer Countersink drill bit Clamps Pencil Shopping List: 3” Screws 8d Finish nails Wood shims Steps: 1. Use a four-foot level to check if the existing floor is level. Make the bubble level and then measure the distance from the floor to the underside of the level. This will determine the long side of the jamb. 2. Measure the height to the jamb header of any existing doors to ensure the new door matches. 3. Use a miter saw to cut the jambs to length. 4. Use a countersinking drill bit to predrill holes in the jamb pieces. Connect the jamb using 3” screws. 5. Mark _” reveal for the casing on the jamb with a pencil. 6. Set the side casing on the line on the jamb and then attach with 8d finish nails. 7. Allow the head casing to overhand the side casing by _” on each side and attach. 8. Attach a temporary filler strip across the bottom of the jamb to hold it square when moved. 9. Test fit the jamb assembly in the opening. 10. Add wood shims to the door framing to make one side of the jamb plumb. 11. Clamp the jamb flush with the drywall or plaster, then screw the jamb through the shims into the framing. 12. Add shims to the other side

Published 2018-12-17 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts