01:54How to Perform a Whole-House Energy Audit | Ask This Old House
From the creator
Kevin O'Connor and a specialist perform a whole-house energy audit. (See steps below.) SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse A professional whole-house energy assessment will examine your home's insulation, appliances, lighting, and heating & cooling systems. It will also determine how airtight your home is. At the end of the assessment, the technician will provide a written report identifying and prioritizing the steps you can take to save energy. For more information about energy audits, visit this U.S. Department of Energy website [https://bit.ly/3f2j252]. Steps for How to Perform a Whole-House Energy Audit: 1. Check the energy rating on each appliance and light fixture. Look for Energy Star label or other low-usage ratings. Replace older products that are wasting electricity. 2. Inspect the water heater, and make note of any leaks, rust spots or lack of insulation. Also, check the heater's age and energy efficiency. 3. Run a combustion safety test of the steam boiler with a combustion analyzer. 4. Use the analyzer to measure the temperature and ratio of gases inside the flue pipe. 5. Next, drill a small-diameter hole in the flue pipe, then use the analyzer to measure the air pressure and to ensure that the boiler is drafting (exhausting) properly. 6. Hold a smoke stick beside the flue to confirm that gases aren't leaking back into the basement. 7. Install an electric blower door in the front doorway to test for air leaks throughout the house.
Published 2016-02-13 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





