13:13How to make a solid walnut picture frame // Woodworking | I Like To Make Stuff
From the creator
I made a beautiful walnut picture frame for my favorite movie poster! KlyeToth Cove Cuts: https://www.youtube.com/watch?v=OLICB02oRss TOOLS & SUPPLIES (affiliate links): https://kit.co/iliketomakestuff/my-woodworking-tools https://kit.co/iliketomakestuff/shop-safety-gear Dark Glue: https://www.amazon.com/dp/B001DT5IPO?tag=ilik-20 FeatherPro feather board: http://amzn.to/2t4ywBh The poster was in an old, cheap plastic frame encased in acrylic instead of glass. Buying a custom cut piece of glass for this poster would be expensive, so I just reused the acrylic and the cardboard backer. Before you cut any material for a picture frame, you need to make sure you have enough material. In this case, I measured the poster and added a 1/4 inch to each side. This measurement would be the inside dimensions of the frame pieces. To get the outside dimension (to make sure you have enough material), I added the thickness of the frame, which was going to be 3 inches, to the inside dimension TWICE, so 6 inches. This ensures that you have the artwork's inside dimension, and enough stock to create a 45 degree angle on both ends. I cut a huge walnut board into 3 inch strips using the table saw. I then used the outer dimension I found in the last step to cut the 4 sides to length. Setting up a physical stop block on your miter saw can help ensure consistent cuts, this is super important when making cleanly-joining corners. If one side is longer than the other, even by a little bit, the corner
Published 2018-03-01 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





