01:39How to Make a Posable Mannequin | I Like To Make Stuff
From the creator
For the past 2 years, I've been building a fully-3d printed set of Shoretrooper armor. It is time to build a posable mannequin so he can become a life-size action figure! PUNISHED PROPS ACADEMY https://www.youtube.com/watch?v=eIf2IbdJKL8&t=469s TOOLS & SUPPLIES (affiliate links): https://kit.co/iliketomakestuff/my-woodworking-tools https://kit.co/iliketomakestuff/shop-safety-gear MUSIC: http://share.epidemicsound.com/iltms Because this armor set was scaled to fit my body, I had to measure my extremities to get an accurate mannequin. Josh marked out my arms, legs, collar bone, and torso lengths with tape while I laid on the floor. We used these measurements as the basis for the PVC pipe segments that would make up the skeleton. Because I want Dan to be able to stand in different poses I needed to factor in some moveable joints. Like a good trooper he is, Dan will always be carrying his rifle in this right hand. That arm should articulate a little, but it needs to be more rigid and strong. The left hand should be more flexible and posable so he can hold the rifle, point at rebel scum, or wave to his fictitious brother Gil. The knees should also bend slightly depending on certain action poses. With these joints in mind, we found some simple PVC solutions at Lowe's. By using threaded unions that can be tightened into different positions, we can give a full range of arm motions when placed in the right location. Placing the unions on the outer collar bone allows the arm to m
Published 2018-11-15 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





