09:49How to Install Crown Molding Around Corners | Ask This Old House
From the creator
In this video This Old House general contractor Tom Silva shows host Kevin O'Connor a tip for installing crown molding around awkward wall angles. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse. General contractor Tom Silva shows Kevin how to handle a common problem: crown molding around awkwardly angled walls. Tom explains that most folks cut returns that avoid the angle rather than wrapping the crown molding around, and that’s not necessarily the best solution. Certain homes like capes and those with gambrel roofs can make installing crown molding very difficult. They often have angled walls (known as cheek walls) formed by roof rafters, and many homeowners don't know how to install crown molding around these walls. Sometimes, folks simply end the molding before the edge of the cheek wall and install returns, but they're often eye-catching and ugly. Others may overrun the cheek wall, leaving a large gap underneath the molding. The tip below is a better option. Difficulty: ⅗ Time: 1 hour Cost: Under $10 Installing Crown Molding Around Corner Angles 1. Cut an outside corner on a miter saw. Remember to cut upside and backward when cutting crown molding angles. Use glue and a couple of small nails to create this joint and allow it to dry. This is a corner template, so using a few scraps of shorter crown molding cut-offs is fine. 2. Place the corner template over the corner. Mark the ceiling along the tops of the molding with a few light pencil marks. Als
Published 2022-07-10 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





