13:51How to Install Bypass Pantry Doors | Ask This Old House
From the creator
Ask This Old House carpenter Nathan Gilbert travels to Missouri to install a set of bypass doors for a pantry. #ThisOldHouse #AskTOH SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 3-4 hours Cost: $150 Skill Level: Moderate Tools: Drill driver [https://amzn.to/35X3hYs] Forstner bit [https://amzn.to/2LpDxKP] Level [https://amzn.to/2WqNcXQ] Measuring tape [https://amzn.to/2WSIS2H] Track saw [https://amzn.to/2zwrcC6] Brad nailer [https://amzn.to/2WRJoOu] Shopping List: Primed trim piece [https://thd.co/2WrCW1u] Interior doors [https://thd.co/2SYElKU] Bypass door hardware kit [https://amzn.to/2LrnRqs] Shims [https://amzn.to/2WRjt9D] Steps for installing bypass doors: 1. Start by prepping the opening of the doors. In some cases, it might be necessary to pad the opening with some primed 2x stock material to ensure the opening is the exact width as the width of the doors. If the width of the opening is the correct dimension, notch out the opening to accept the trim piece, which will be added later to hide the track once its installed. 2. Hold the track up to the top of the opening and mark the holes for the screws. 3. Remove the track and drill pilot holes on the marks. 4. Secure the track to the top of the opening using screws that come with the kit. 5. Check the track for level. If it’s out of level, the top of the opening can be padded out with a few shims. 6. Hang the roller hardware into the track. Measure from the bottom of the floor to th
Published 2020-05-18 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





