05:08🫧✨ MY SPARKLING SLIME SQUISHY! + MORE DIY Crafts for KIDS 🫵🔥
PlayToon Land – Fun Adventure
Ask This Old House plumbing and heating expert Richard Trethewey installs a water conditioner to combat hard water SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 2-3 hours Cost: $1000 and Up Skill Level: Moderate Tools List for Installing a Water Conditioner: Pipe cutter Drill driver Level Tape measure Shopping List: Citrus conditioner system Scrap plywood Screws Sandpaper Solder Flux Pipe Pipe fittings Rags Steps: 1. Before doing any work on the plumbing system, ensure that water is turned off at the main shutoff. 2. Locate an area on the wall near the water main where the citrus conditioner can be installed. Ensure the location has enough clearance for the filters to be easily changed. 3. Locate studs in the wall and mount a piece of scrap wood to the structure to serve as a backer for the conditioner using a drill driver and screws. 4. Assemble the citrus conditioner using the instructions with the kit. Screw the mounting brackets to the heads of the filter, then attach the unit into the plywood backer board on the wall. 5. Measure, cut, and dry fit the pipes to connect the main water line to the conditioner. Cut the pipes with the pipe cutter and clean the ends with sandpaper before dry fitting. 6. Disassemble the pieces, apply flux to the pipe and fittings, and then solder the connections. 7. Install the cartridges to the filter. The carbon filter should be installed immediately downstream from the main water shutoff, and the citrus conditi
Published 2017-10-08 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.
05:08PlayToon Land – Fun Adventure
02:59
3:03:47
03:05
1:01:45
01:53Panel Stories
28:37Allow Google Analytics to measure visits. Your history stays in your browser. Privacy details