01:54How to Install a Touchless Kitchen Faucet | Ask This Old House
From the creator
Plumbing and heating expert Richard Trethewey helps a homeowner install a new, no-touch kitchen faucet. (See below for a shopping list, tools, and steps.) SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Shopping List for How to Install a Touchless Kitchen Faucet: - Touchless kitchen faucet - Small bucket, used to collect water Tools List for How to Install a Touchless Kitchen Faucet: - Basin wrench, for disconnecting water-supply lines from sink - Screwdriver - Cordless drill Steps for How to Install a Touchless Kitchen Faucet: 1. Close the hot- and cold-water shutoff valves underneath the sink. 2. Use a basin wrench to disconnect both water-supply lines from the underside of the sink. 3. Twist off the hand sprayer from the spray hose, then pry off the retainer clip with a narrow screwdriver or a pocketknife. 4. Pull the sprayer base off of the spray hose, then push the hose down through the sink deck and into the cabinet below. 5. Drain the water from the spray hose into a bucket. 6. Pull out and discard the old faucet. 7. Place the new faucet's mounting plate and gasket onto the sink deck. 8. Set the faucet in place by feeding its hoses and data cable down through the hole in the mounting plate. 9. From below, slide the ends of the hoses and cable through the support bar and mounting washer. 10. Thread on the hex nut and tighten with the supplied wrench to lock the faucet to the sink. 11. Feed the soap dispenser through the old hand-sprayer hole in the s
Published 2016-04-26 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





