tubeshowcase●1,673,521 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts09:19

How to Install a Combination Boiler/Water Heater | Ask This Old House

This Old House ↗

From the creator

This Old House plumbing and heating expert Richard Trethewey replaces a water heater and boiler with a single unit that's much more efficient. (See below for a shopping list, tools, and steps.) SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Richard replaces an old water heater and heating boiler with a single unit that is much more efficient. Shopping List for How to Install a Combination Boiler/Water Heater: - Plywood panel, used for mounting new combination boiler[BR] - Combination boiler/water heater, including mounting hardware - PVC pipe and fittings - Outdoor temperature sensor - PVC condensate line with limestone neutralizer - Condensate pump   Tools List for How to Install a Combination Boiler/Water Heater: - Screwdriver - Drill/driver with 4-inch hole saw - Tape measure Steps for How to Install a Combination Boiler/Water Heater: 1. Mount a plywood panel to the basement wall to serve as a mounting panel for the new combination boiler. 2. Run new gas, electrical, and plumbing lines to the plywood panel. 3. Screw the metal mounting brackets to the plywood panel, then hang the combination heater onto the brackets. 4. Drill two 4-inch-diameter holes through the house wall for the exhaust vent and air intake vent. Be sure the air intake is above the snow line, and that the exhaust vent is 12 inches from a window and 12 inches from the air intake. 5. Use PVC pipe and fittings to create the exhaust and air intake vents. Run the piping from the boiler th

Published 2015-11-14 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts