02:47DIY✨ Galaxy glitter🪩 bookmark!! #shorts #trending #craft #ytshorts #viral #diycrafts #craftideas
Twinnies Fun world
Ask This Old House plumbing and heating expert Richard Trethewey helps a homeowner figure out why one of her radiators is not working. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Richard identified that the 1950s era home he visited was piped with a diverter tee setup, where a single, combined supply and return line runs from the boiler.In part of Richard’s explanation on the radiator, he explained the diverter tee in the dual piping to each radiator. The diverter tee slow-stems the flow of water at one end, increasing the back pressure and forcing the water through the first pipe and into the radiator. Time: varies Cost: varies Skill Level: Difficult Steps: 1. Richard goes over some of the places to check when adequate heat is not being delivered from a forced hot water heating system. 2. In this home, which means the water heats up in the boiler, goes up through the pipes, through the radiators, gives off heat to the room, and falls back down to the boiler to be heated again. That process is helped via an electric circulator pump which can be tested to ensure it is working properly. 3. With any forced hot water system, there must be the right amount of water pressure going into the boiler and to the pipes. To help that, a pressure reducing valve lessens the amount of water pressure from the city to the boiler. The pressure reducing valve can be tested and a pressure gauge on the boiler will also indicate system pressure. 4. An expansion tank
Published 2017-01-30 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.
02:47Twinnies Fun world
01:32Daisy Arts
03:01
11:39123 GO! FOOD
10:02
03:34
01:40𝚌𝚞𝚝&𝚌𝚘𝚕𝚘𝚛 𝚋𝚢 𝚊𝚖𝚒
Allow Google Analytics to measure visits. Your history stays in your browser. Privacy details