35:15How to Cut Wood Joints | Generation Next | Ask This Old House
From the creator
Ask This Old House general contractor Tom Silva teaches apprentice Austin how to make a variety of different wood joints by building simple utility boxes. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 2-3 hours Cost: $50 Skill Level: Beginner-Expert, depending on the joint Tools List for Cutting Wood Joints: Table saw Miter saw Dado blade Table saw blade Clamps Safety glasses Hearing protection Shopping List: Lumber _” plywood Wood glue Wood screws Steps: 1. Cut the lumber to desired length using a table saw or a miter saw. 2. Cut the _” plywood to size for three boxes based on the previous cuts made. The plywood will serve as a bottom for all the boxes. RABBET-BUTT JOINT 3. Set the dado blade in the table saw to just slightly above the thickness of the board. 4. Hold the board on its long side and eyeball the desired thickness of the rabbet cut. Slide the rip fence against the board and lock it down when the gap between the rip fence and the blade are at the desired thickness. 5. With the board still standing upright, run it through the table saw. 6. Repeat this process on the other side of the board, and then again on the board that will be parallel to this one on the completed box. 7. Switch the dado blade to a table saw blade and make a cut on all four boards the thickness of the bottom of the box to receive the bottom of the box. 8. Cover all the joints with wood glue and assemble the first three sides. 9. Slide the bottom into the dados, t
Published 2018-04-29 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





