tubeshowcase●1,673,666 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts06:48

How to Create Simulated Panels with Molding | Ask This Old House

This Old House ↗

From the creator

Ask This Old House general contractor Tom Silva creates a simulated stile and rail wainscoting on a dining room wall by using base cap molding. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 4-5 hours Cost: Under $100 Skill Level: Moderate Tools List: Miter saw 23-gauge pin nail gun Measuring tape Rag Caulking gun Shopping List: 1/16” x 1 3/8” primed finger jointed base cap molding 23-gauge headless pin nails Wood glue Wood filler Fine grit sandpaper Caulk 1x4 scrap wood for a gauge block Steps: 1. Measure the height of the space between the chair rail and the baseboard using a measuring tape. 2. The base cap molding frame should be centered all around the room. An easy way to measure, take two pieces of 1x4 and place them against the top of the baseboard and the bottom of the chair rail. The distance between the two blocks is a good height for the frame. 3. To get the horizontal measurements of the frame, measure the entire width of your wall. Divide the measurement up evenly and allow for spacing between each frame. Using a piece of 1x4 as a gauge block between each frame is a good way to separate the frames evenly. 4. To cut the vertical portion of the frames, set the stop on the outfeed of a miter saw and place the base cap molding just beyond the stop. 5. Set the miter saw to a 45-degree angle, hold the molding tight to the saw and make the first cut. Repeat the process for the necessary amount of vertical sides. 6. Reverse the angle of the

Published 2017-02-20 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts