13:51How to Connect an Ice Maker Like a Pro | Ask This Old House
From the creator
Ask This Old House plumbing and heating expert Richard Trethewey helps a special homeowner hook up her refrigerator with an ice maker. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 2-3 hours Cost: $30 Skill Level: Moderate Tools List for Connecting an Ice Maker: Drill [https://amzn.to/2mSflaY] Feeler bit [https://amzn.to/2m2QEZg] Pipe cutter [https://amzn.to/2m2Sycm] Bucket [https://amzn.to/2nxt07O] Wrench [https://amzn.to/2n0kFJj] Shopping List: 1/4 inch copper tubing [https://amzn.to/2mYRAxW] Copper T fitting [https://amzn.to/2n0ODNl] Multi-turn shut off valve [https://amzn.to/2npTub8] with a compression connection [https://amzn.to/2lk9laA] Abrasive cloth [https://amzn.to/2m27305] Pipe cleaner [https://amzn.to/2mSs6T8] Solder [https://amzn.to/2nyU9r7] Flux [https://amzn.to/2lrdIAU] Flux brush [https://amzn.to/2nxnDFF] Steps: 1. Shut the water off to the house. 2. Locate the nearest cold water line and determine its location compared to the location of the fridge. 3. With that in mind, pull out the fridge and drill down with a feeler bit as close to the cold water line as possible. 4. Use the feeler bit to determine the best location to drill for the water line. Drill the hole. 5. Carefully uncoil the copper tubing and run it through the hole and close to the water line. 6. Determine where the water line will be cut. Clean that area with the abrasive cloth and cut it with a pipe cutter. Have a bucket ready to catch any water that comes out. 7. O
Published 2018-05-14 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





