35:15How to Bring Hot Water Outside | Ask This Old House
From the creator
Ask This Old House plumbing and heating expert Richard Trethewey helps a homeowner add an outdoor faucet with both hot and cold water. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 4 hours Cost: $700 Skill Level: Moderate Tools List for Bringing Hot Water Outside: Compact pipe cutter Drill with hole saw attachment Torch Adjustable pliers Shopping List: Frost proof wall hydrant Solder Flux Copper female adapters Copper pipe and fittings Thread sealing tape Silicone caulking All weather screws Steps: 1. Before doing any plumbing work, turn the water off at the water main. 2. Use the compact pipe cutter to cut the cold line to the existing outdoor faucet. With the line cut, remove the old faucet. 3. Measure the center to center distance between the hot and cold pipes on the new faucet. 4. Transfer that measurement to the wall, using the old cold line hole as a reference for the new hot hole. 5. Use the drill with a hole saw attachment to drill a hole for the new hot water line. 6. Loosen and remove the stem units so the washers on them aren’t destroyed by heat when soldering. 7. Use thread sealing tape on the male ends of the wall hydrant, then thread on copper female adapters. 8. Cut two pieces of copper pipe about a foot long to fit through the wall. 9. Clean the inside of the female adapter and the outside of the copper pipe using plumber’s sand paper and apply flux to those same spots. Solder the joint together using the torch an
Published 2018-06-29 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





