tubeshowcase●1,673,666 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts10:47

How to Brick Veneer a Fireplace | Ask This Old House

This Old House ↗

From the creator

Ask This Old House mason Mark McCullough replaces a homeowner’s sloppy fireplace surround with a clean, thin brick veneer SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 4-5 hours Cost: $400 Skill Level: Difficult Tools List for Brick Veneer: [YT] Safety glasses [https://amzn.to/35zUZ8k] Chisel [https://amzn.to/2pj15JD] Hammer [https://amzn.to/31ozqo8] Brick ruler [https://amzn.to/31ghgoj] Trowel [https://amzn.to/32lpRaO] Level [https://amzn.to/31e3oLb] Tuck pointer [https://amzn.to/2MlyxZf] Masonry brush [https://amzn.to/2MgRnjS] Shopping List: [YT] Thin brick [https://amzn.to/33CG77A] Painters tape [https://amzn.to/2MiQWG4] Thinset [https://amzn.to/2nOpYwt] Type N mortar [https://amzn.to/2q9tuCf] Steps: 1. Start by removing the old veneer. Take a chisel and a hammer and try to cut the thin stones until you can get the chisel behind it. Then, use the chisel and hammer to pry it off from behind. This process sends chips of stone flying, so wear safety glasses to protect your eyes. 2. Template for the new thin brick. Mark used a brick ruler to get the spacing just right and also save time, but it’s possible to also eyeball it as long as you mark each individual thin brick. Painter’s tape can be used to mark each spot. 3. Apply the thin bricks with a thinset, same as with tiling, and a trowel. Check for level every few bricks. 4. Fill in the joints with Type N mortar and a tuck pointer. 5. Brush off any excess mortar using the masonry brush. Re

Published 2019-10-22 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts