tubeshowcase●1,672,197 videos♡ My collection 0
← DIY & Crafts

DIY & Crafts09:39

Holiday Toy Box | Build It | Ask This Old House

This Old House ↗

From the creator

Ask This Old House general contractor Tom Silva and host Kevin O’Connor build a toy box for Tom’s grandson. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 4 hours Cost: $100 Skill Level: Moderate Tools List for Building a Holiday Toy Box: Miter saw Table saw Router and rabbeting bit Pocket screw jig Drill Clamps Palm sander Jigsaw Brad nailer and compressor Shopping List: 1x4” pine boards 1x8” pine boards 1/2” plywood birch panels Pocket screws Wood glue 80-100 grit sandpaper Brad nails Steps: 1. Cut the 1x4” boards to a desired rough length using a miter saw. 2. Lay out the boards for the front, back, and bottom of one side. Use the fourth piece to determine the angle for the top of the box. Mark the boards at a desired angle and cut it using the miter saw. 3. Repeat this process for the other side of the box. 4. Cut the stiles and rails for the front of the box at the desired length. 5. Using the table saw, cut dados along the perimeters of the side of the stiles receiving the panel and cut rabbets into the 1/2” plywood for the sides and front of the box. Keep the panel flush with the backs of the stiles and rails. Be careful to not cut the dados all the way through each board. 6. Cut the panels to size. The ones on the side should be at the same angle as the stiles. 7. Use the router to cut the rabbet on all the panels. 8. Assemble the sides using pocket screws and wood glue. Slide the panels in before securing the fourth stile. 9. Fill the poc

Published 2017-11-20 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.

Keep exploring DIY & Crafts