01:54Hawaiian Mango Keepsake Box | Build It | Ask This Old House
From the creator
Ask This Old House general contractor Tom Silva works with a local woodworker to build a keepsake box out of mango wood. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Time: 6 hours Cost: $300 Skill Level: Moderate Tools List: Wide belt sander Jointer Table Saw Band Saw Flush cut saw Drill press Shopping List: Mango wood 3/8” thick Koa wood 1/4” thick Scrap pieces of Cuban mahogany Polyurethane glue Paste wax Super glue 5mm barrel hinges Steps: 1. If using a slab, ensure it has been dried to 14% humidity, then run it through a wide-belt sander to make it level. 2. Run the piece through a jointer to get a straight edge, then run it through a table saw to remove the live edge and cut the lumber into a piece about 8” wide. 3. Cut the dimensioned lumber into pieces about 3/8” thick on the band saw. Run the piece through a wide belt sander again. 4. Cut a dado that will hold the bottom in place on the table saw. 5. Sand the piece that will serve as the sides with fine grit sandpaper, starting at a 220 grit and ending at 1200 grit. 6. Apply a finish to the dado side of the board using polyurethane glue. Dab a few drops of glue, then carefully work the glue into the wood grain using a finishing rag. 7. Wipe down the finish after application and then again every 10-15 minutes until the glue has cured. 8. After the glue has cured, sand the piece again using 1200 grit sandpaper. 9. Apply a paste wax for the final finish. 10. Cut the pieces to length on a table
Published 2017-06-04 · Watch on YouTube ↗
Availability and playback restrictions are controlled by the original channel.





